Table of Contents
Advertisement
Appendix A: RF Troubleshooting
change if RX channel is changed. VC is lower on lower channels and higher if higher channel
numbers are used.
4.2.4.8.1.1 VCP1-voltage ok?
•
WCDMA receiver has to be active before VCP1 voltage can be measured. Procedure is explained in
section "Receiver troubleshooting".
Measurement can be done with an oscilloscope and a probe.
•
•
Connect the probe to C7507.
•
VCP1 voltage should be about 4.75 V.
4.2.4.8.1.1.1 C7507 and C2222 working properly?
•
Check that the components are in place and solder joints are ok
•
Disconnect the power supply from the phone and use an ohmmeter to check that C507 and C2222
are not short-circuited.
4.2.4.8.1.1.2 Retu ok?
4.2.4.8.1.1.3 Hinku (N7500) ok?
4.2.4.8.1.2 Balun T7501 ok?
•
WCDMA receiver has to be active before RX VCO's output frequency and output level can be
measured. Procedure is explained in section "Receiver troubleshooting".
•
Measurements can be done with a spectrum analyser and an RF probe. Spectrum analyser centre
frequency should be set according the used RX channel (see section "Frequency mappings"). RBW
and VBW = 1 MHz, Span ≤ 200 kHz.
•
Check the level of the VCO frequency in T7501 outputs. The level should be about -25...-35 dBm. If
the signal level is correct in the input (about -20...-30 dBm) but output level is not as expected
then replace T7501.
4.2.4.8.1.3 Are components near the RX VCO ok?
R7501, C7516, R7505, C7524 and C7522 working correctly?
•
Check that components are in place and solder joints are ok
•
Disconnect the power supply from the phone and check resistors resistance values with an
ohmmeter.
•
Use an ohmmeter to check also that capacitors are not short-circuited
4.2.4.8.1.4 Replace Hinku (N7500) or RX VCO (G7500) or both
4.2.4.8.2 Replace RX VCO G7500
4.2.4.9 Is RX VCO signal level in the T7501 output high enough?
Company Confidential
Copyright © 2005 Nokia. All rights reserved
Nokia Customer Care
A-105
Advertisement
Chapters
Table of Contents
Troubleshooting
