Table of Contents
Advertisement
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell
certified service technicians.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Install the processor.
4.
Keep the Phillips #2 screwdriver ready.
Steps
1.
If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint-free cloth.
2.
Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the top of the processor.
CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and contaminating
the processor socket.
NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.
Figure 76. Applying thermal grease on the top of the processor
1.
processor
3.
thermal grease syringe
3.
Place the heat sink onto the processor.
4.
Tighten one of the four screws to secure the heat sink to the system board.
5.
Repeat the procedure for the remaining two screws.
2.
thermal grease
115
- Quick Links:
- Memory Specifications
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
