537-8001-02
Detection Description
Remedy
537-8002-02
Detection Description
Remedy
a. Front Alignment Motor error (Finisher-H1) b. Error in the Rear Alignment Motor (Finisher-
Y1)
a. The Front Alignment Plate HP Sensor was not turned OFF although 1 second had passed after
the Front Alignment Motor operation started.
b. The rear alignment plate does not come off the Rear Alignment HP Sensor when the Rear
Alignment Motor has been driven for 1 second.
a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Rear Alignment HP Sensor (PS116) to the Finisher Controller PCB
- Harnesses from the Rear Alignment Motor (M108) to the Finisher Controller PCB
- Rear Alignment HP Sensor (PS116)
- Rear Alignment Motor (M108)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
a. Front Alignment Motor error (Finisher-H1) b. Error in the Rear Alignment Motor (Finisher-
Y1)
a. The Front Alignment Plate HP Sensor was not turned ON although 5 seconds had passed after
the Front Alignment Motor operation started.
b. The Rear Alignment HP Sensor does not detect the rear alignment plate when the Rear
Alignment Motor has been driven for 1 second.
a. INNER FIN-H1
[Related parts]
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Plate HP
Sensor
- Harnesses and connectors from the Finisher Controller PCB to the Front Alignment Motor
- Front Alignment Plate HP Sensor (PS4)
- Front Alignment Motor (M3)
- Finisher Controller PCB (PCB1)
b.STAPLE FIN-Y1/BOOKLET FIN-Y1
[Related parts]
- Harnesses from the Rear Alignment HP Sensor (PS116) to the Finisher Controller PCB
- Harnesses from the Rear Alignment Motor (M108) to the Finisher Controller PCB
- Rear Alignment HP Sensor (PS116)
- Rear Alignment Motor (M108)
- Finisher Controller PCB (PCB101)
[Points to note at work] When the Swing Guide Safety Switch (SW102) turns on at the detection
timing of this error, this error code may be displayed. Accordingly, perform the following work before
checking the related parts.
1. Check whether there is not the mulfunction in the swing guide unit.
2. Check whether there is not the mulfunction in the Swing Guide Safety Switch (SW102).
[Remedy] Check/replace the related harness/cable, connector and parts.
[Reference] When replacing the Finisher Controller PCB, refer to "Adjustment> When Replacing
the Parts" in the Service Manual.
536
7. Error/Jam/Alarm