Table of Contents
Advertisement
COPIER > OPTION > FNC-SW
DMX-DISP
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
INVALPDL
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
IMGCNTPR
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
CDS-FIRM
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Supplement/Memo
ON/OFF auto grdtn adj D-max PASCAL ctrl
To set whether to execute D-max PASCAL control at auto gradation adjustment (full adjustment).
When 0 is set, D-max PASCAL control and PASCAL control are executed. Four A4-size sheets
are used for test print (one for D-max PASCAL control and three for PASCAL control).
When 1 is set, only PASCAL control (gradation adjustment) is executed. Three A4-size sheets are
used for test print (for PASCAL control).
According to the usage of the user
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ON, 1: OFF
0
Disable of PDL license
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To disable the registered PDL license.
When "1: Disabled" is set, PDL is disabled even if a PDL license is registered. This is set to the
machines installed at convenience stores, which do not allow PDL to be used.
When prohibiting the use of PDL
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Registered PDL license is enabled, 1: Disabled
0
Setting of image quality mode
To set the image quality mode.
The counter priority mode is applied when 1 is set, and the image quality priority mode is applied
when 0 is set.
Upon user's request
Enter the setting value, and then press OK key.
0 to 2
0: Image quality priority mode, 1: Counter priority mode
1
Set to allow firmware update by admin
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to permit update of the firmware by user (administrator).
When "1: Enabled" is set, Updater can be activated from the user mode.
When allowing the administrator to update the firmware
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Do not use it for purposes other than collecting log files. In Japan, the firmware cannot be updated
by user. Be sure to return the value to 0 after use.
0 to 1
0: Disabled, 1: Enabled
It differs according to the location.
CDS: Contents Delivery System
907
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
