hit counter script

Canon imageRUNNER ADVANCE C5500 Series Service Manual page 489

Hide thumbs Also See for imageRUNNER ADVANCE C5500 Series:
Table of Contents

Advertisement

● Procedure for Setting the Startup Collection Function
1. Set "1" in the following service mode to enable this function.
• (Level2) COPIER > Test > NET-CAP > PONSTART
• 0: Data is not automatically collected at startup (factory setting value).
• 1: Data is automatically collected at startup.
Setting this service mode automatically starts collecting packet data if the condition of network packet capture operation is
satisfied when the main power of the host machine is turned ON. Completion of packet data collection needs to be executed
manually.
● Procedure for Executing the File Deletion Function
1. Execute the following service mode to delete the collected packet data.
• (Level2) COPIER > Test > NET-CAP > FILE-CLR
Delete all the network packet capture data stored on the hard disk.
■ Start / Stop the Network Packet Capture Function
● Operation
To start or stop capturing network packets, set "0" or "1" in the following service mode.
• (Level2) COPIER > Test > NET-CAP > STT-STP
0: The capture function is not available.(factory setting value)
1: The capture function is available.
CAUTION:
Be sure to stop the network packet capture function after collecting network packet capture data.
● Checking the Status of Capturing
Execute the following service mode to check the status of capturing.
• (Level2) COPIER > Test > NET-CAP > CAPSTATE
The following types of status are displayed.
RUNNING :
Packets are being captured.
STOP :
Packet capturing is stopped.
HDDFULL :
The maximum amount of 1 GB of packets has been captured.
NOTE:
Packets are not collected if the machine enters deep sleep mode while capturing.However, capturing is resumed when the machine
recovers from sleep mode.
475
6. Troubleshooting

Advertisement

Table of Contents
loading

Table of Contents

Save PDF