Installing The Optical Drive Cage Or Tape Drive - Dell EMC PowerEdge T440 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge T440:
- Installation and service manual (156 pages) ,
- Simple operation manual (9 pages) ,
- Manual (150 pages)
Table of Contents
Advertisement
Figure 39. Removing the optical drive cage or tape drive
Next steps
Install the optical drive cage or tape
Installing the optical drive cage or tape drive
Prerequisites
NOTE:
The procedure to install the optical drive cage is the same as installing the tape drive.
Follow the safety guidelines listed in
Steps
1. Unpack and prepare the drive for installation.
For instructions, see the documentation that shipped with the drive.
If you are installing a SAS tape drive, you must have an internal tape adapter installed. For more information on installing a
SAS tape drive, see the
2. If applicable, remove the existing drive or the drive blank.
3. Align the guide on the drive with the slot on drive bay.
4. Slide the drive into the slot until the latch clicks into place.
5. Connect the power and data cable to the drive.
6. Connect the power and data cables to the backplane and the system board.
drive.
Safety
instructions.
Installing an expansion card
section.
Installing and removing system components
51
Advertisement
Table of Contents
