hit counter script

Processors And Heat Sinks; Removing A Processor And Heat Sink Module - Dell EMC PowerEdge T440 Installation And Service Manual

Hide thumbs Also See for EMC PowerEdge T440:
Table of Contents

Advertisement

Figure 70. Installing optional IDSDM/vFlash card
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2. Follow the procedure listed in

Processors and heat sinks

Removing a processor and heat sink module

Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system is powered down. Allow the heat
sink to cool before removing it.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Using a Torx #T30 screwdriver, loosen the screws on the heat sink in the order below:
a. Loosen the first screw three turns.
b. Loosen the second screw completely.
c. Return to the first screw and loosen it completely.
2. Pushing both blue retention clips simultaneously, lift the processor and heat sink module (PHM) processor and heat sink
module
3. Set the PHM aside with the processor side facing up.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
83

Advertisement

Table of Contents
loading

Table of Contents