Table of Contents
Advertisement
Figure 110. Installing the BOSS S2 module blank
Next steps
Replace the BOSS S2
module.
Installing the BOSS S2 module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4. If installed,
remove the front
5. Disconnect the cables connected to the system board.
Steps
1. If installed, remove the BOSS S2 module blank using a flat head screwdriver.
Figure 111. Removing the BOSS S2 module blank
2. Align the BOSS S2 module to the BOSS S2 slot on the chassis and push it into the slot.
3. Using a Phillips 2 screwdriver, secure the BOSS S2 module to the system.
Safety
instructions.
Before working inside your
bezel.
system.
Installing and removing system components
113
- Quick Links:
- System Memory
Hide quick links:
Advertisement
Table of Contents
