Integrated Storage Controller Card - Dell EMC PowerEdge R730xd Owner's Manual
Hide thumbs
Also See for EMC PowerEdge R730xd:
- Owner's manual (239 pages) ,
- Deployment manual (78 pages) ,
- Technical manual (64 pages)
Table of Contents
Advertisement
Steps
1. Align the cable retention bracket with the alignment pins on the chassis.
2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the keyhole slots.
3. Place all cables to be routed in the cable retention bracket.
Figure 49. Installing the cable retention bracket
1. alignment pin (2)
3. tab
Next steps
1. Install the PCIe card holder.
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions
on page 67
Related tasks
Before working inside your system
Removing the cooling shroud
Removing the PCIe card holder
Installing the cooling shroud
Installing the PCIe card holder
After working inside your system
Integrated storage controller card
Your system includes a dedicated expansion card slot on the system board for an integrated storage controller card. The
integrated storage controller card provides the integrated storage subsystem for the internal hard drives in your system.The
controller supports SAS and SATA hard drives and also enables you to set up the hard drives in RAID configurations. The RAID
configurations depend on the version of the storage controller included with your system. The controller supports SAS hard
drives.
112
Installing and removing system components
on page 68
on page 75
on page 107
on page 76
on page 108
on page 68
2. keyhole slot
4. cable retention bracket
- Quick Links:
- Hard Drives
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
