Removing Expansion Card Risers - Dell EMC PowerEdge R730xd Owner's Manual
Hide thumbs
Also See for EMC PowerEdge R730xd:
- Owner's manual (239 pages) ,
- Deployment manual (78 pages) ,
- Technical manual (64 pages)
Table of Contents
Advertisement
Removing expansion card risers
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove any expansion card installed on risers 2 and 3.
The expansion card riser 1 can be used only when both the processors are installed.
NOTE:
Steps
1. Holding the slots on the expansion card riser, lift the riser from the riser connector on the system board.
2. To remove expansion card risers 2 and 3, hold the edges of the expansion card riser, and lift the riser from the riser
connector on the system board.
To ensure proper cooling, the riser 1 blank must be installed in the riser 1 slot. Remove the riser 1 blank only if you
NOTE:
are installing riser 1.
Figure 60. Removing the expansion card riser 1
1. expansion card riser 1 cage
3. riser guide-back (right)
5. expansion card riser 1 connector
2. expansion card riser 1
4. riser guide-back (left)
6. riser guide-front
Installing and removing system components
127
- Quick Links:
- Hard Drives
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
