Show Interface Output; Adapter Properties - Dell EMC VxFlex Ready Node User Manual
Hide thumbs
Also See for EMC VxFlex Ready Node:
- Operating system installation manual (74 pages) ,
- Operating system installation manual (86 pages) ,
- Installation manual (92 pages)
Table of Contents
Advertisement
Figure 26 Show interface output
In this example, index 17 is the appropriate network.
3. Type the command:
netsh interface ipv4 set subinterface <network_ID> mtu=9000
store=persistent
network_ID is the ID from the output in the previous step; in this case,
where,
the ID is 17.
4. In the Advanced tab of the Adapter Properties dialog for your vendor and
driver, change the value of Jumbo Packet to
following figure:
Figure 27 Adapter properties
5. Click OK.
The network connection may disconnect briefly during this phase.
6. Verify that the configuration is working, by typing the command:
ping –f –l 8972 <Destination_IP_Address>
Output similar to the following should be displayed:
VxFlex OS performance fine-tuning
9000 , as illustrated in the
Dell EMC VxFlex Ready Node AMS User Guide
119
- Quick Links:
- Introduction to Vxflex Ready Node
- Hardware
Hide quick links:
Advertisement
Chapters
Table of Contents
