Table of Contents
Advertisement
Figure 26. Removing the drive from the drive carrier
Next steps
1.
Replace the drive into the drive
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in
2.
Remove the front
bezel.
3.
Remove the drive
carrier.
Steps
1. Insert the drive into the drive carrier with the connector end of the drive towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips 1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive)
screwdriver to install the drive.
42
Installing and removing system components
carrier.
Safety
instructions.
Advertisement
Table of Contents
