Table of Contents
Advertisement
Figure 70. Installing the BOSS S2 card carrier
Next steps
1. Connect the BOSS S2 power and signal cables to the connectors on the BOSS S2 module and system board.
NOTE:
Insert the BOSS S2 power and signal cable through the cable clip.
2. Follow the procedure listed in the
3.
Install the front
bezel.
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. If you are replacing the IDSDM card, remove the MicroSD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
81
Advertisement
Table of Contents
