Table of Contents
Advertisement
Figure 72. Installing the IDSDM module
Next steps
1.
Install the MicroSD
cards.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2.
Install the air
shroud.
3. Follow the procedure listed in the
MicroSD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the IDSDM
module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more
information on the IDSDM module location, see
2. Hold the MicroSD card, and remove them from the IDSDM module.
NOTE:
Temporarily label each MicroSD card with the corresponding slot number after removal.
After working inside your
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
system.
Installing and removing system components
section.
83
Advertisement
Table of Contents
