Removing A Cabled Psu - Dell G0N7D Installation And Service Manual

Table of Contents

Figure 80. Installing a power supply unit

Next steps

1. Connect the power cable to the PSU, and plug the cable into a power outlet.

CAUTION:

When connecting the power cable to the PSU, secure the cable to the PSU with the strap.

NOTE:

When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the

PSU and determine its status. The PSU redundancy may not occur until discovery is complete. The PSU status indicator

turns green to indicate that the PSU is functioning properly.

NOTE:

For certain premium configurations with high power consumption, system PSU might stay with 2+0 mode only, 1+1

redundant mode is not available.

NOTE:

While replacing the hot swappable PSU, after next server boot; the new PSU automatically updates to the same

firmware and configuration of the replaced one. For more information about the Part replacement configuration, see the

Lifecycle Controller User's Guide at https://www.dell.com/idracmanuals.

Removing a cabled PSU

Prerequisites

1. Follow the safety guidelines listed in

2. Follow the procedure listed in

3. Disconnect the power cables of the PSU from the system board and the drive backplane.

4. Remove the cables from the cable clip.

Steps

1. Using a Phillips 2 screwdriver, remove the screws that secure the PSU cage to the system.

2. Tilt at an angle and slide the PSU cage towards the front of the system.

3. Lift the PSU cage out of the system.

Safety

instructions.

Before working inside your

system.

Installing and removing system components

Table of Contents

Poweredge t350 742k8