Table of Contents
Advertisement
Figure 62. Installing the BOSS S2 card carrier blank
Removing the BOSS S2 module
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in the
Before working inside your
system.
3.
Remove the front
bezel.
4. Disconnect the BOSS S2 power and signal cable from the BOSS S2 module and the system board.
Steps
1. Pull and lift the BOSS S2 card carrier retention latch lock to open.
2. Slide the BOSS S2 card carrier out.
Installing and removing system components
75
Advertisement
Table of Contents
