Table of Contents
Advertisement
Next steps
1. If applicable, connect the cables to the expansion card.
2.
Install the expansion card
3.
Install the air shroud
or
4. Follow the procedure listed in
5. Install any device drivers required for the card as described in the documentation for the card.
Removing the full length expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the GPU air shroud top
4. If applicable, disconnect the cables from the expansion card or system board.
5.
NOTE:
If BOSS-N1 module is installed, be sure to disconnect the BOSS-N1 power cable and Signal cable before
removing the Riser 1 cage.
Steps
1. To remove full length expansion card riser:
a. Loosen the captive screws on the riser.
b. Press the blue release tab and holding the edges, lift the expansion card riser from the riser connector on the system
board.
c. Disconnect the GPU power cable and signal cable from the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
risers.
install the GPU air
shroud.
After working inside your
Safety
instructions.
Before working inside your
cover.
system.
system.
Installing and removing system components
253
Hide quick links:
Advertisement
Table of Contents
