Table of Contents
Advertisement
Figure 264. Installing the GPU board
Next steps
1.
Install the GPU and GPU cold
2.
Install the sensor
tray.
3. Plug the cold plate tubes to the Manifold Liquid cooling module.
4.
Slide in the system board
5. Reconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module.
6.
Install the lower brace
7. Reconnect all the cables onto the system board. For more information, see
8.
Install the
risers.
9.
Install the storage tray
10.
Install the VSB cables on the system
11. Follow the procedure listed in the
Removing the GPU cold plate for NVIDIA configurations
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Disconnect the cables from the connector on the system board and the storage tray.
4.
Remove the VSB from the system board
5.
Remove the storage
tray.
6.
Remove the risers
and keep the risers away from the system board tray and no need to disconnect the cables from the PSB.
7. Disconnect all the cables from the system board and make note of all the cable connections. For more information, see
Cabling
diagram.
8.
Remove the lower brace
9. Disconnect the liquid cooling tubes 11 and 12 from the Manifold for DLC module and keep in on the system board and make
sure do not damage any connectors on the system board.
240
Installing and removing system components
plates.
tray.
bracket.
.
board.
After working inside your
Safety
Before working inside your system
and keep it on the storage tray and no need to disconnect from the PDB2.
bracket.
system.
instructions.
.
Cabling
diagram.
Advertisement
Table of Contents
