Table of Contents
Advertisement
Steps
1. Place the power-supply unit and the power-supply unit connector on the display-assembly base.
2. Align the screw holes on the power-supply unit with the screw holes on the display-assembly base.
3. Replace the three screws (M3x5) that secure the power-supply unit to the display-assembly base.
4. Align the screw holes on the power-supply connecty bracket with the screw holes on the display-assembly base.
5. Replace the two screws (M3x5) that secure the power-supply connector bracket to the display-assembly base.
6. Connect the processor-power cable to its connector (ATX CPU) on the system board.
7. Connect the control-signal cable to its connector (CTRL) on the system board.
8. Connect the system-board power cable to its connector (ATX SYS) on the system board.
Next steps
1. Install the
I/O
cover.
2. Install the
system-board
3. Install the
back
cover.
4. Install the stand.
5. Follow the procedure in
78
Removing and installing Customer Replaceable Units (CRUs)
shield.
After working inside your
computer.
Advertisement
Table of Contents
