Depth Gauge - Makita DHR202 Instruction Manual

Cordless combination hammer

Hide thumbs Also See for DHR202:

Available languages

Installing or removing the bit

Clean the bit shank and apply bit grease before install-

ing the bit.

► 1 . Bit shank 2. Bit grease

Insert the bit into the tool. Turn the bit and push it in until

it engages.

► 1 . Bit 2. Chuck cover

If the bit cannot be pushed in, remove the bit. Pull the

chuck cover down a couple of times. Then insert the bit

again. Turn the bit and push it in until it engages.

After installing, always make sure that the bit is securely

held in place by trying to pull it out.

To remove the bit, pull the chuck cover down all the way

and pull the bit out.

► 1 . Bit 2. Chuck cover

Bit angle (when chipping, scaling or

demolishing)

► 1 . Action mode changing knob 2. O symbol

The bit can be secured at the desired angle. To change

the bit angle, depress the lock button and rotate the

action mode changing knob to the O symbol. Turn the

bit to the desired angle.

Depress the lock button and rotate the action mode

changing knob to the

the bit is securely held in place by turning it slightly.

Depth gauge

► 1 . Depth gauge

The depth gauge is convenient for drilling holes of

uniform depth. Loosen the side grip and insert the depth

gauge into the hole in the side grip. Adjust the depth

gauge to the desired depth and tighten the side grip.

8 ENGLISH

symbol. Then make sure that

Table of Contents