Removing And Installing Parts; Before You Begin; Recommended Tools; Turning Off Your Computer - Dell Dimension 5150 Owner's Manual
Dell dimension 5150: owners manual
Hide thumbs
Also See for Dimension 5150:
- Service manual (73 pages) ,
- Setup (2 pages) ,
- Owner's manual (164 pages)
Table of Contents
Advertisement
Removing and Installing Parts
Before You Begin
This chapter provides procedures for removing and installing the components in your computer.
Unless otherwise noted, each procedure assumes that the following conditions exist:
•
You have performed the steps in "Turning Off Your Computer" on page 59 and "Before Working
Inside Your Computer" on page 60.
•
You have read the safety information in your Dell™ Product Information Guide.
•
A component can be replaced or—if purchased separately—installed by performing the removal
procedure in reverse order.
Recommended Tools
The procedures in this document may require the following tools:
•
Small flat-blade screwdriver
•
Phillips screwdriver
•
Flash BIOS update program floppy disk or CD
Turning Off Your Computer
NOTICE:
To avoid losing data, save and close any open files and exit any open programs before you turn off
your computer.
1 Shut down the operating system:
Save and close any open files, exit any open programs, click the Start button, and then click
a
Turn Off Computer.
In the Turn off computer window, click Turn off.
b
The computer turns off after the operating system shutdown process finishes.
2 Ensure that the computer and any attached devices are turned off. If your computer and attached
devices did not automatically turn off when you shut down your operating system, press and hold
the power button for 4 seconds.
Removing and Installing Parts
59
- Quick Links:
- Inside View of Your Computer
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
