When Using Your Computer
Ground yourself by touching the unpainted metal surface of the I/O panel on the back of
4
the computer.
While you work, periodically touch the I/O panel to dissipate any static electricity that
might harm internal components.
Protecting Against Electrostatic Discharge
Static electricity can harm electronic components inside your computer. To prevent static
damage, discharge static electricity from your body before you touch any of your computer's
electronic components, such as a memory module. You can do so by touching an unpainted
metal surface on the computer's I/O panel.
As you continue to work inside the computer, periodically touch an I/O connector to remove
any static charge your body may have accumulated.
You can also take the following steps to prevent damage from electrostatic discharge (ESD):
•
When unpacking a static-sensitive component from its shipping carton, do not remove
the component from the antistatic packing material until you are ready to install the
component. Just before unwrapping the antistatic packaging, be sure to discharge static
electricity from your body.
•
When transporting a sensitive component, first place it in an antistatic container or
packaging.
•
Handle all sensitive components in a static-safe area. If possible, use antistatic floor pads
and workbench pads.
Battery Disposal
Your computer uses an lithium-ion battery and a coin cell battery. For instructions about
replacing the lithium-ion battery in your computer, refer to the section about replacing the
battery in your Dell computer documentation. The coin-cell battery is a long-life battery, and it
is very possible that you will never need to replace it. However, should you need to replace it,
the procedure must be performed by an authorized service technician.
Do not dispose of the battery along with household waste. Contact your local waste disposal
agency for the address of the nearest battery deposit site.
(continued)
W h e n U s i n g Yo u r C o m p ut e r
15