Dell XPS M2010 Owner's Manual page 130
Dell laptop owner's manual
Hide thumbs
Also See for XPS M2010:
- Service manual (132 pages) ,
- Owner's manual (117 pages) ,
- Setup manual (2 pages)
Table of Contents
Advertisement
NOTICE:
To avoid damaging the system board, you must remove the main battery before you begin working inside
the computer. See "Replacing the Battery" on page 55.
The computer has two memory slots, DIMM A and DIMM B, located under the memory module cover.
If you replace or upgrade the memory in your computer, both memory modules must be the same size.
To install a memory module in DIMM A or DIMM B:
1 Follow the procedures in "Before You Begin" on page 127.
2 Turn the computer over, loosen the captive screw on the memory cover, and then remove the cover by
sliding it toward the back of the computer to disengage the tabs on the base from the notches in the
cover, then lifting the cover off.
3 Ground yourself by touching one of the metal connectors on the back of the computer.
NOTE:
If you leave the area, ground yourself again when you return to the computer.
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory-module
securing clips.
4 If you are replacing a memory module, remove the existing module:
Use your fingertips to carefully spread apart the securing clips on each end of the memory module
a
connector until the module pops up.
Remove the module from the connector.
b
130
Adding and Replacing Parts
1
captive screw
1
- Quick Links:
- Front View
Hide quick links:
Advertisement
Table of Contents
