Table of Contents
Advertisement
3. Levels 1 and 2 Support
To update (flash) the BIOS, see "Updating (flashing) BIOS from a disc" on page 554.
Updating (flashing) BIOS from a disc
This section provides instructions on how to update (flash) BIOS from a disc. System BIOS program updates
are available at:
http://www.lenovo.com/support
To update (flash) BIOS from a disc:
1. Make sure the optical drive you want to use is set as the first boot device in the startup device sequence.
See "Selecting a startup device" on page 41.
2. Make sure the computer is turned on. Then, insert the system program update (flash) disc into the
optical drive.
3. Turn the computer off and back on again. The update begins.
4. When prompted to change the serial number, press Y.
5. Type in the twenty character serial number of your computer and then press Enter.
6. When prompted to change the machine type/model, press Y.
7. Type in the twenty character machine type/model of your computer and then press Enter.
8. Follow the instructions on the screen to complete the update.
Recovering from a POST/BIOS update failure
If the power to your computer is interrupted while POST/BIOS is being updated (flash update), your computer
might not restart correctly. If this happens, perform the following procedure which is commonly called
Boot-block Recovery.
1. Turn off the computer and any attached devices, such as printers, monitors, and external drives.
2. Unplug all power cords from electrical outlets, and remove or open the computer cover. See "Removing
the computer cover" on page 69 or "Opening the computer cover" on page 103.
3. Depending on your machine type, you might need to lay the computer on its side for easier access to
the system board or you might need to pivot the optical drive bay assembly upward and or remove
the hard disk drive to access the system board, see "Accessing the system board components and
drives" on page 104.
4. Locate the Clear CMOS/Recovery jumper on the system board. See "Locating parts on the system
board" on page 72 or "Locating parts on the system board" on page 106.
5. Remove any cables that impede access to the Clear CMOS/Recovery jumper.
6. Move the jumper from the standard position (pin 1 and pin 2) to pin 2 and pin 3.
7. Reconnect any cables that were disconnected.
8. Reinstall or close the computer cover and reconnect the power cords for the computer and monitor
to electrical outlets. See "Completing the FRU replacement" on page 99 or "Completing the FRU
replacement" on page 127.
9. Turn on the computer and the monitor, and then insert the POST/BIOS update (flash update) disc
into the optical drive.
10. Turn the computer off and back on again.
11. The recovery session will take two to three minutes. During this time you will hear a series of beeps. After
the update session is completed, there will be no video, the series of beeps will end, and the system will
automatically turn off. Remove the disc from the optical drive before the system completely turns off.
12. Repeat steps 2 through 5.
554
ThinkCentre Hardware Maintenance Manual
Hide quick links:
Advertisement
Table of Contents
