Control Panel Setup; Network Menu; Tcp/Ip - Brother MFC-9130CW Network User's Manual
Multi-protocol on-board ethernet multi-function print serever and wireless multi-function print server
Hide thumbs
Also See for MFC-9130CW:
- Service manual (429 pages) ,
- Basic user's manual (226 pages) ,
- Advanced user's manual (100 pages)
Table of Contents
Advertisement
4
Control panel setup
Network menu
The Network menu selections of the control panel allow you to set up the Brother machine for your network
configuration. (For more information on how to use the control panel: see Basic User's Guide.) Press
All Settings and then press Network. Proceed to the menu selection you wish to configure. (For
additional information on the menu, see Function table and default factory settings on page 49.)
Please note that the machine is supplied with the BRAdmin Light utility
2
Remote Setup
applications, which also can be used to configure many aspects of the network. (See Other
Management Utilities on page 8.)
1
For Macintosh users, you can download Brother's latest BRAdmin Light utility from http://solutions.brother.com/.
2
Not available for DCP models.
TCP/IP
If you connect the machine with a network cable to your network, use the Wired LAN menu selections. If
you connect the machine to a wireless Ethernet network, use the WLAN menu selections.
Boot Method
This selection controls how the machine obtains an IP address.
Auto mode
In this mode, the machine will scan the network for a DHCP server. If it can find one, and if the DHCP server
is configured to allocate an IP address to the machine, then the IP address supplied by the DHCP server will
be used. If no DHCP server is available, the IP Address is set using the APIPA protocol. After the machine is
initially powered ON, it may take a few minutes for the machine to scan the network for a server.
Static mode
In this mode the machine's IP address must be manually assigned. Once entered the IP address is locked to
the assigned address.
NOTE
If you do not want your print server configured via DHCP, BOOTP, or RARP, you must set the
BOOT Method to Static so that the print server has a static IP address. This will prevent the print server
from trying to obtain an IP address from any of these systems. To change the Boot Method, use the
machine's control panel, BRAdmin Light utility, Web Based Management, or Remote Setup.
1
, Web Based Management or
4
4
,
4
4
4
4
4
36
Hide quick links:
Advertisement
Table of Contents
