Table of Contents
Advertisement
NOTICE: You must match the colored strip on the EIDE cable with pin 1 on the IDE1 connector to avoid possible damage to your
system. Pin 1 is indicated by a silk-screened "1" printed on the system board.
3. If it is not already connected, connect the other end of the EIDE cable to the appropriate EIDE interface connector on the system board.
To locate the IDE1 connector on the system board, see
4. Connect a DC power cable into the power input connector on the back of the drive (see
Check all connectors to be certain that they are properly cabled and firmly seated.
5.
Replace the computer
cover. Then reconnect your computer and peripherals to their electrical outlets, and turn on the peripherals.
6. Insert a bootable diskette into drive A, and turn on the computer system.
7.
Reset the chassis intrusion
8. Partition and logically format your drive before proceeding to the next step.
See the documentation for your operating system for instructions.
9. Install your operating system on your hard-disk drive.
Refer to the documentation that came with your operating system.
System Power Supply
System Power Supply Rotation
To access some components on the system board, you may have to rotate the system power supply out of the way. To rotate the power supply,
perform the following steps:
1. Remove the
computer
cover.
2. Disconnect the AC power cable from the AC power receptacle on the back of the power supply (see Figure 13).
Figure 13. System Power Supply Rotation
3. Free the power supply from the securing tab labeled "RELEASE—>, " and rotate it upward until it locks in its extended position.
System Power Supply Removal
1 Interface connector
2 Power input connector on drive
3 Lip
4 Rail
5 IDE1 connector
6 IDE2 connector
7 DC power cable
8 EIDE cable
Figures 19 and 20.
detector. While in System Setup, update the Drive 0 option under Primary Drive n.
1 Securing tab
2 Power supply
3 Release latch
4 AC power cable
Figure
12).
Advertisement
Table of Contents
