Table of Contents
Advertisement
MONITOR
MOUSE
PANEL
PARALLEL
PCIn*
POWER_1
POWER_2
RISER
SERIALn
SLOT1_PRI
USB
Expansion Cards
Each GX200 chassis can accommodate 32-bit PCI expansion cards and 16-bit and 8-bit ISA expansion cards, depending on the installed riser
board. See Figure 26 for examples of the expansion cards.
Figure 26. Expansion Cards
Expansion Card Removal
To remove an expansion card, perform the following steps:
1.
Remove the computer
cover.
2. If necessary, disconnect any cables connected to the card.
3. Remove the screw from the mounting bracket of the card you want to remove.
4. Grasp the card by its outside corners, and ease it out of its connector.
5. If you are removing the card permanently, install a metal filler bracket over the empty card-slot opening.
NOTE: Installing filler brackets over empty card-slot openings is necessary to maintain Federal Communications
Commission (FCC) certification of the system and keep dust and dirt out of your computer.
6.
Replace the computer cover
Expansion Card Installation
Figure 27. Expansion Card Installation
Video connector
Mouse connector
Control panel connector
Parallel port connector; sometimes referred to as LPT1
PCI expansion-card connector
Main power input connector
3.3-V power input connector
Riser board connector
Serial port connector
Primary microprocessor connector
USB connectors
1 8-bit ISA expansion card
2 16-bit ISA expansion card
3 32-bit PCI expansion card
and
reset the chassis intrusion
detector.
Advertisement
Table of Contents
