Sanyo XHS1271 Technical & Service Manual page 104
Dc inverter split system air conditioner
Hide thumbs
Also See for XHS1271:
- Specifications (2 pages) ,
- Instruction manual (16 pages) ,
- Installation instructions manual (36 pages)
Table of Contents
Advertisement
How to Test Run the Air Conditioner
After turning on the power of the air conditioner, use the
remote controller and follow the steps below to conduct
the test run.
(1) Set the remote controller in Test Run mode. (Fig. 29)
a)Press and hold the HIGH POWER button and the
1HR. TIMER button.
b)Then press and hold the ACL (Reset) button with
a pointed object such as the tip of a pen. After 5
seconds, release the ACL button first.
c) Then release the HIGH POWER and 1HR. TIMER
buttons.
d)
appears and "oP-1" blinking in the remote con-
troller clock display area. (Fig. 30)
(2) Start Cooling mode test run by pressing the ON/OFF
operation button of the remote controller. (Fig. 29)
• This starts the fan producing uncooled forced air
with the 3 indicator lamps (OPERATION lamp,
TIMER lamp, and HIGH POWER lamp) on the
main unit blinking. (Fig. 31)
• After 3 minutes, the system shifts into cooling
operation, and cool air will start to be felt. Cooling
mode test run is unaffected by the room tempera-
ture.
(3) Press the ON/OFF operation button of the remote
controller again to stop the test run. (Fig. 29)
(4) Finally press the ACL (Reset) button of the remote
controller to release it from Test Run mode to return
to normal mode. (Fig. 29)
• "
" and "oP-1" will disappear from the remote
controller clock display area.
NOTE
Troubleshooting:
In the event that the green OPERATION lamp is blinking
upon powering up the system, an error condition exists.
In this case, refer to the self-diagnostics procedure
which can be seen by opening the air-intake grille.
IMPORTANT
After the test run is completed, be sure to press the ACL
(Reset) button to return to normal mode. The air condi-
tioner will not operate correctly if this is not done.
HIGH POWER
button
REMOTE CONTROL receiver
19
ON/OFF
operation
button
1HR.
TIMER
button
ACL
(Reset)
button
Fig. 29
Fig. 30
OPERATION button
OPERATION lamp
TIMER lamp
HIGH POWER lamp
Fig. 31
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
