Sanyo XHS1271 Technical & Service Manual page 74
Dc inverter split system air conditioner
Hide thumbs
Also See for XHS1271:
- Specifications (2 pages) ,
- Instruction manual (16 pages) ,
- Installation instructions manual (36 pages)
Table of Contents
Advertisement
REMOTE CONTROL UNIT
Transmitter
When you press the buttons on the remote control unit, the
appears in the display to transmit the setting changes to the receiver
in the air conditioner.
Display
Information on the operating conditions is displayed while the remote
control unit is switched on. If the unit is turned off, FLAP setting and
FAN SPEED setting are not displayed.
HIGH POWER button
: If this button is pressed during HEAT, DRY, COOL or FAN operation,
the unit operates at maximum output for 30 minutes, regardless of
the desired temperature.
The fan speed is 1step above ''HIGH''.
FAN SPEED selector button
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
FLAP button
Press this button either to select the setting of the airflow direction to the auto.
flap in each mode or one of the six possible positions manually or to select the
sweep function which moves the flap up and down automatically.
: Auto flap setting: If selected in a heating operation, the flap is set to
position (3) in the following chart. If selected in a cooling or dry
operation, the flap is set at position (7) in the following chart.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
NOTE
When you press the FLAP button, the air flow direction will be changed one by
one as follows.
ON TIME/OFF TIME setting buttons
Advance button
Return button
No display: The timer does not operate.
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
: The air conditioner stops and starts, or starts and
stops, at the set times every day. For details, see
"SETTING THE TIMER".
CANCEL button
SENSOR button
When you press this button (use a small-tipped object such as a ballpoint
pen), the
mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
NOTE
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the SENSOR button to switch to the
sensor on the indoor unit.
ADDRESS switch
• The address switch changes to prevent mixing of signals from remote control units
when two air conditioners are installed next to each other. Normally, the address switch
is set to A. For more information, please contact the dealer where you made the
purchase.
• Normally, the tabs on the remote control unit should not be bent.
6
mark
SWEEP
Temperature display selector button
This switches the temperature display
between °C and °F.
OI-107-6-EG
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
