Front I/O Panel - Dell XPS M2010 Service Manual
Hide thumbs
Also See for XPS M2010:
- Owner's manual (194 pages) ,
- Service manual (77 pages) ,
- Setup manual (2 pages)
Table of Contents
Advertisement
1. Slide the power supply into place, ensuring that the tabs on the rear wall of the computer chassis latch into place.
2. Replace the four screws that secure the power supply to the back of the computer chassis.
3. Replace the two hard-drive bays.
4. Replace all hard drives installed in the interior hard-drive bays (see
5. Replace the optional hard-drive fan, if applicable (see
6. Reattach each of the DC power cables that were previously connected, carefully rerouting them as you found them.
7. Replace the computer cover (see
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
8. Connect your computer and devices to electrical outlets, and then turn them on.
Front I/O Panel
Front I/O-Panel Components
1 IEEE 1394
2 USB 2.0 ports (2)
connector
4 headphone
5 microphone
connector
connector
Removing the Front I/O Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Remove any full-length expansion cards (see
Installing the Optional Hard Drive
Replacing the Computer
Cover).
3 diagnostic, hard-drive access, and network
integrity lights
Begin.
Removing the Computer
Cover).
Removing PCI and PCI Express
Installing a Hard
Drive).
Fan).
Cards).
- Quick Links:
- Front View
- Removing the Computer Cover
Hide quick links:
Advertisement
Table of Contents
