2F48-2F52/4001-401D Codes - Canon iPF9000S Troubleshooting Manual
Ipf5000, ipf700, ipf8000, ipf800, ipf650/750 series
Hide thumbs
Also See for iPF9000S:
- User manual (832 pages) ,
- Troubleshooting manual (191 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Panel display
Code
(last 4
Large LCD
digits)
2F48
Hardware error.
03130031-2F48
Turn off printer,wait,
then turn on again.
2F49
Hardware error.
2F50
03130031-ｘｘｘｘ
2F51
Turn off printer,wait,
then turn on again.
2F4A
Hardware error.
03130031-2F4A
Turn off printer,wait,
then turn on again.
2F52
Hardware error.
03130031-2F52
Turn off printer,wait,
then turn on again.
4001
ERROR
E146-4001
Call for service.
401A
ERROR
E602-401A
Call for service.
401B
ERROR
E602-401B
Call for service.
401C
ERROR
E198-401C
Call for service.
401D
ERROR
E198-401D
Call for service.
Small
Small
LCD 1
LCD 2
VHT (heater drive drive power supply for
printhead) error
VHT has gone below or above the rating.
Printhead short-circuited detected.
Prior to VH power on, it has been detected
that the printhead had been damaged due to
paper jam etc, and ink went inside the
terminal area causing near short-circuit.
2F49: L side printhead
2F50: R side printhead
2F51: LR both printhead
Main PCB error.
Detected that a CR unit of a legacy model
has been mounted (iPF8300/6300/6350
only).
ERROR
Borderless/flow pre-ejection/mist recovery
E146-40
count full
01
Call For
Service
HDD failure
Failed to read and write to and from the
HDD.
Poor HDD connection
The HDD and the HDD controller are not
indefinable.
ERROR
Faulty RTC
E198-40
Any error other than the two errors
1C
mentioned below has been detected while
Call For
initializing the RTC at startup.
Service
ERROR
RTC low battery error
E198-40
A battery error has been detected while
1D
initializing the RTC at startup.
Call For
Service
2-51
Explanation/Detection sequence
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
iPF6300 series
①Replace the
printhead.
②Replace the
main PCB.
iPF8300 series
①Replace the
printhead.
②Replace the CR
relay board.
③Check/ replace
the long flexible
cable.
④Replace the
main PCB.
iPF6300 series
①Replace the
printhead
②Replace the
main PCB.
iPF8300 series
①Replace the
printhead
②Replace the CR
relay board
③Check/ replace
the long flexible
cable.
④Replace the
main PCB.
Replace the main
PCB.
Replace with an
appropriate CR
unit.
Check the parts
counter and
replace the target
unit or Refresh
Service Kit.
Initialize the parts
counter for the
target unit after
the replacement.
①Replace the
HDD.
①Remove and
insert the
HDD.
②Replace the
HDD.
①Restart the
printer in
service mode.
②Replace the
main PCB.
①Restart the
printer in
service mode.
②Check the
RTC battery.
③Replace the
main PCB.
Hide quick links:
Advertisement
Table of Contents
