Maintenance; Address Setting Of The Remote Control Unit - Sanyo SAP-KRV96EHDS Technical & Service Manual
Dc inverter split system air conditioner
Hide thumbs
Also See for SAP-KRV96EHDS:
- Installation instructions manual (24 pages) ,
- Installation instructions manual (28 pages)
Table of Contents
Advertisement
8. MAINTENANCE
8-1. Address Setting of the Remote
Control Unit
The address can be set in order to prevent
interference between remote controllers when two
indoor units are installed near each other. The
address is normally set to "A." To set a different
address, it is necessary to change the address on the
second remote controller.
NOTE
Once changed, you cannot restore the original
address setting of the air conditioner.
(1) Switch on the power source.
(2) Break the address-setting tab marked "A" on the
second remote controller to change the address
(Fig. 13). When the tab is removed, the adress is
automatically set to B (Fig. 14).
(3) Press and hold the remote controller LED CLEAN
button and 1 HR TIMER button. At the same time,
press the ACL(reset) button. Use a thin object
such as the tip of a pen to press the ACL button.
When this has been done, "oP-1" (test run)
appears, blinking, in the remote controller clock
display area.
(4) Each time the 1 HR TIMER button is pressed, the
display changes as shown below. Press this
button 2 times to change the display to "oP-7"
(address setting). (Fig. 15)
Test run mode
Self-diagnostic mode
Address setting mode
(5) "oP-7" has now been selected for address setting.
(6) Press the ON/OFF operation button on the remote
controller. (Fig. 15) Check that the "beep"
signalreceived sound is heard from the second
indoor unit (approximately 5 times). The sound
you hear is the signal that the remote controller
address has been changed.
(7) Finally press the remote controller ACL (reset)
button to cancel the blinking "oP-7" display. (Fig.
15)
Changing of the second remote controller address is
now completed.
Tab
LED CLEAN
button
29
Fig. 13
Fig. 14
LED C
LED
CLEAN
ON/OFF
operation
button
1 HR.TIMER
button
ACL (Reset)
button
Fig. 15
ACL button
- Quick Links:
- Unit Specifications
- Operation Functions
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
