Dell Precision WorkStation 610 User Manual page 89
Mini tower systems
Hide thumbs
Also See for Precision WorkStation 610:
- User manual (230 pages) ,
- Documentation update (8 pages) ,
- Service manual (96 pages)
Table of Contents
Advertisement
Each of these switches has two positions, or settings (usually on and off). To change the setting of a slide switch, use a small,
pointed object such as a small screwdriver or a straightened paper clip to slide the switch to the proper position. To change the
setting of a rocker switch, use the screwdriver or paper clip to press down on the appropriate side of the switch. In either case, do
not use a pen, pencil, or other object that might leave a residue on the switch.
Figure B-1. System Board Jumpers
Table B-1. System-Board Jumper Settings
Jumper
Setting
SPREAD
RSVD4
RSVD3
RSVD2
RSVD1
450MHZ*
400MHZ*
350MHZ
TOWER
BIOS
PSWD
* One set of the speed jumper pins must have a jumper plug installed; otherwise, the system will operate at an undetermined
Description
Reserved (do not remove jumper).
Reserved (do not install jumper plug).
Reserved (do not install jumper plug).
Reserved (do not install jumper plug).
Reserved (do not install jumper plug).
Jumpered when the processor's internal speed is 450 MHz.
Jumpered when the processor's internal speed is 400 MHz.
Reserved (do not install jumper plug).
System board is installed in a mini tower chassis (do not install jumper plug).
Reserved (do not install jumper plug).
Password features enabled.
Password features disabled.
Advertisement
Table of Contents
