2) The environment of the room must be as indicated in the following diagram, and the machine must not be installed near a water faucet, water boiler, humidifier,

or refrigerator:

[A]: Zone A: Satisfies all the conditions of the standard image quality and paper feed performance.

[B]: Zone B: Inferior to Zone A in terms of the standard image quality and paper feed performance, or may not apply.

[C]: Zone C: Problems associated with safety, malfunctions, or incorrect message display do not occur, but image quality and paper feed performance are

not guaranteed.

3) The machine must not be installed near a source of fire or in an area subject to dust or ammonium gas.

If the area is exposed to direct rays of the sun, provide curtains to the window.

4) The level of ozone generated by the machine will not affect the health of individuals around it. Some, however, may find its odor unpleasant as while remaining

in contact with it for long hours. Be sure that the room is well ventilated.

5) The floor of the machine must be level so that the feet of the machine will remain in contact and the machine will remain level.

6) The machine must be at least 10 cm away from any wall, permitting unobstructed use.

7) The machine must be placed in a well ventilated area. It is important to make sure, however, that the machine is not near the air vent (for suction) of the room.

2.1.2 Before Starting the Work (230V CENV)

iR2022i / iR2018i

1-1 Points to Make Before Installation

Be sure to go through the following before starting the work:

1) If you are installing the machine after moving it from a cold to warm location, be sure to leave the machine unpacked for at least 2 hours so that the machine is

fully used to the site temperature, thus avoiding image faults caused by condensation. (The term "condensation" refers to the formation of droplets of water on

the surface of a metal object brought in from a cold to warm place, i.e., as the result of the rapid cooling of the moisture (vapor) around the object.)

(%RH)

100

[C]

[B]

[A]

7.5

27.5

32.5

F-2-1

100 mm min.

1247 mm

F-2-2