The following procedure enables you to hide the destination name that is printed at the sender information area on the receiving side. This function is useful

when you register destination names in the abbreviated form. However, please note that this function is not available for the iR3300 series machines.

In user mode [Communication Settings > TX Settings under Common Settings > TX Terminal ID > Display Destination Name], select [OFF].

14.2.10.3.6 Characteristics of direct sending: FAX transmission

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 / / / /

[ Manual-related ]

Description

Unlike the direct sending function of the conventional machines, the function of this machine has the following characteristics.

1. Communication time is considerably reduced.

2. After negotiation with the machine on the FAX receiving side, this machine scans up to ten sheets of original.

3. This function cannot be used in combination with the Stamp function.

14.2.10.3.7 Message "FAX TX is not possible with this mode set" is displayed

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 / / / /

[ Case in the field ]

Description

In the field, the message was displayed because the stamp function was set in combination with the direct sending mode. When the message appears, change

the FAX sending mode to the memory sending or disable the stamp function.

14.2.10.3.8 Is it possible to install Multi Line Fax Board-D1 (2 lines) in Fax model?

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 / / / /

[ Case in the field ]

Description

It is possible to install the Multi Line Fax Board-D1 to a Fax model. When installing the board, however, follow the field remedy below.

Field Remedy

Detach the standard Fax board from the model and then install the Multi Line Fax Board-D1 (2 lines board).

14.2.10.3.9 FAX TX REPORT and TX REPORT are output when FAX transmission ends in error: FAX transmission

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 / / / /

[ Manual-related ]

Description

These two reports are set to be output by default. If TX REPORT is not necessary, follow the procedure below.

[User mode > Report Settings > Send under Settings > TX Report > OFF].

14.2.10.3.10 How to enable Incoming Ring function: Auto FAX reception

iR2270 / iR2870 / iR3570 / iR4570 / / / / / iR2230 / / / iR3530 / / / /

[ Manual-related ]

Description

To enable the incoming ring function, follow the procedure below.

1. Install the optional handset or a telephone set in the machine.

2. In user mode [Communication Settings > RX Settings under FAX Settings > Incoming Ring > ON].

3. Hold down the control panel switch for more than 3 seconds, press the Start button on the LCD, and then turn the main power switch OFF referring to the

instruction on the LCD.

4. Wait 10 seconds or more, and then turn the main power switch ON again to enable the incoming ring function.