Packing And Shipping The Machine - Brother MFC-J2510 Basic User's Manual
Hide thumbs
Also See for MFC-J2510:
- Basic user's manual (212 pages) ,
- User manual (89 pages) ,
- Quick setup manual (47 pages)
Table of Contents
Advertisement
Packing and shipping
the machine
When you transport the machine, use the
packing materials that came with your
machine. Follow the instructions below to
correctly package your machine. Damage
caused to your machine during transit may
not be covered by your warranty.
The machine should be adequately insured
with the carrier.
IMPORTANT
It is important to allow the machine to
"park" the print head after a print job.
Listen carefully to the machine before
unplugging it to make sure that all
mechanical noises have stopped. Not
allowing the machine to finish this process
may lead to print problems and possible
damage to the print head.
a
Unplug the machine from the electrical
socket.
b
Using both hands, use the finger holds
on each side of the machine to lift the
scanner cover into the open position.
Then unplug the machine from the
telephone wall socket and take the
telephone line cord out of the machine.
c
Unplug the interface cable from the
machine, if it is connected.
d
Lift the scanner cover (1) to release the
lock. Gently push the scanner cover
support down (2) and close the scanner
A
cover (3) using both hands.
e
Open the ink cartridge cover.
f
Remove all four ink cartridges. Press
the ink release lever above each
cartridge to release it. (See Replacing
the ink cartridges on page 86.)
g
Install the orange protective part and
then close the ink cartridge cover.
Routine maintenance
1
3 3
2
A
93
Advertisement
Table of Contents
