Clearing Cmos Settings - Dell XPS 600 Service Manual
Hide thumbs
Also See for XPS 600:
- Owner's manual (166 pages) ,
- Setup manual (2 pages) ,
- Owner's manual (166 pages)
Table of Contents
Advertisement
5. After the Microsoft® Windows® desktop appears on your computer,
6. Turn off the monitor and disconnect it from the electrical outlet.
7. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system
board.
8.
Open the computer
9. Locate the 3-pin password jumper on the
password feature.
10.
Replace the computer
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into your
computer.
11. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
1. Follow the procedures in
2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (CLR CMOS) on the system board (see
b. Remove the jumper plug from pins 1 and 2.
c. Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 1 and 2.
3.
Close the computer
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into your
computer.
4. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
cover.
system board
cover.
"Before You
Begin."
cover.
shut down the
and attach the jumper to pins 1 and 2 to re-enable the
"System Board
computer.
Components").
Advertisement
Table of Contents
