Display Assembly And Display Latch - Dell Inspiron 510m Service Manual

Hide thumbs Also See for Inspiron 510m:

Table of Contents

Back to Contents Page

Display Assembly and Display Latch

Dell™ Inspiron™ 510m Service Manual

Display Assembly

Display Bezel

Display Panel

Display Latch

Display Assembly

CAUTION:

Before performing the following procedures, read the safety instructions in your Owner's Manual.

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such

as the back panel) on the computer.

NOTICE:

You must remove the display assembly before you remove the palm rest.

1. Follow the instructions in

"Preparing to Work Inside the

2. Remove the keyboard.

3. Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.

4. Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.

5. Release the display cable from the three display-cable routing clips.

6. Release the two antenna cables from the two antenna-securing clips.

7. Disconnect one antenna cable from the display by holding the two gold antenna connectors and gently pulling them apart. Then disconnect the other

antenna cable. (The gold antenna connectors on each cable are keyed to ensure that they are correctly reconnected.)

Computer."

Table of Contents