Canon ImageRunner iR8500 Series Service Manual page 973
Hide thumbs
Also See for ImageRunner iR8500 Series:
- Service manual (813 pages) ,
- Servise manual (655 pages) ,
- Function manual (167 pages)
Table of Contents
Advertisement
Sub-item
TR-SP-C2
Use it to set the transfer/separation output setting when the left deck is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C3
Use it to set the transfer/separation output setting when the cassette 3 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-C4
Use it to set the transfer/separation output setting when the cassette 4 is used,
thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-MF
Use it to set the transfer/separation output setting when the manual feed tray
is used, thereby preventing faults otherwise occurring.
<Setting value>
0: setting for plain paper (default)
1: setting for recycled paper
2: setting for tracing paper
TR-SP-DK
Use it to set the transfer/separation output setting when the side paper deck is
used.
<Setting value>
0: setting for plain power (default)
1: setting for recycled paper
2: setting for tracing paper
DEV-SLOW
Use it to set the speed of the developing sleeve.
<Setting value>
0: in relation to environment
1: fixed to high speed
2: fixed to low speed (default)
STPL-SFT
Use it to specify where to execute shift stacking in staple mode.
<Setting value>
0: perform shift stacking in staple mode (as it is: default)
1: do not perform shift stacking in staple mode
BASE-SW
Switching from the MEAP-Full mode to the Base model
<Setting value>
0: OFF (Base model), 1: ON (Full model)
SC-L-CNT
switches the thresh value for the scan counter (large/small).
Setting value:
0 (B4 as threshold) or 1 (LTR as threshold)
default: 0
IDL-MODE
Use it to select idle rotation mode for the developing assembly.
MEMO:
Set it to '2' or '3' if the image becomes distorted or too light.
<Setting value>
0: OFF (no idle rotation)
1: auto control based on readings of environment sensor (default)
2: start idle rotation when fixing roller temperature reaches 100 deg C
3: start idle rotation when main power switch goes ON
SCANSLCT
Turning ON or OFF the function of calculating a scan area from the selected
paper size
<Setting value>
0: OFF (Determining the scan area by document detection)
1: ON (Determining the scan area by paper size)
OHP-TEMP
Use it to switch among temperature settings for transparency mode.
MEMO:
The fixing temperature will be lowered to improve separation of
transparencies from the fixing roller.
<Setting value>
0: 198 deg C (default)
1: 193 deg C
2: 188 deg C
3: 183 deg C
COPIER > OPTION > BODY
Description
Chapter 17
Level
1
1
1
1
1
1
1
1
1
2
2
2
17-129
Advertisement
Chapters
Table of Contents
Troubleshooting
