Related Manuals for Makita 6226d
Summary of Contents for Makita 6226d
- Page 1 Cordless Driver Drill MODEL 6226D MODEL 6227D MODEL 6228D 002036 I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
-
Page 2: Specifications
SPECIFICATIONS Model 6226D 6227D 6228D Steel 10 mm Wood 21 mm 24 mm Capacities Wood screw 5.1 mm x 38 mm 5.1 mm x 63 mm Machine screw 6 mm High 0 - 1,100 No load speed (min 0 - 350... -
Page 3: Safety Instructions
SAFETY INSTRUCTIONS ENA002-2 WARNING: When using battery operated tools basic safety precautions, including the following, should be followed to reduce the risk of fire, leaking batteries and personal injury: Read these instructions before operating this product and save these instructions. 14. - Page 4 ADDITIONAL SAFETY RULES FOR TOOL ENB022-1 Be aware that this tool is always in an operating Be sure no one is below when using the tool in condition, because it does not have to be high locations. plugged into an electrical outlet. Hold the tool firmly.
-
Page 5: Functional Description
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 002050 • Always switch off the tool before insertion or removal of the battery cartridge. - Page 6 Speed change 002096 To change the speed, first switch off the tool and then slide the speed change lever to the “II” side for high speed or “I” side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job.
-
Page 7: Operation
OPERATION Screwdriving operation 002134 CAUTION: • Adjust the adjusting ring to the proper torque level for your work. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in. -
Page 8: Maintenance
• Always secure small workpieces in a vise or similar hold-down device. • If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. MAINTENANCE CAUTION: •... - Page 9 Memo...
- Page 10 Memo...
- Page 11 Memo...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884293E221...