Welcome Thank you for choosing the Cisco 200 Series Smart Switch, a Cisco network communications device. This device is designed to be operational right out-of-the-box as a standard bridge. In the default configuration, it will forward packets between connecting devices after powered up.
19-inch rack. For stability, load the rack from the bottom to the top, with the AUTION heaviest devices on the bottom. A top-heavy rack is likely to be unstable and might tip over. Cisco 200 Series Smart Switches...
Cisco strongly recommends using Cat5 or better cable for Gigabit connectivity. When you connect your network devices, do not exceed the maximum cabling distance of 100 meters (328 feet). It can take up to one minute for attached devices or the LAN to be operational after it is connected.
The switch is to be connected only to PoE networks without ARNING routing to the outside plant. If your switch is one of the Power over Ethernet (PoE) models, consider the following power requirement: 200 Series Switches with Power Over Ethernet Model Power Number of Ports PoE Standard...
PD, you should disconnect the device from the PoE port and power recycle the device with AC power before reconnecting its PoE ports. Configuring the Cisco 200 Series Smart Switches Before You Begin Verify the managing computer requirements in the product release notes.
Page 7
Enter the default login information: • Username is cisco • Default password is cisco (passwords are case sensitive) If this is the first time that you have logged on with the default Change Password Page username and password, the opens. The rules for constructing a new login and password are displayed on the page.
Page 8
Make sure that no other device is using the same IP address as the switch. No IP route: If the switch and your computer are in different IP subnets, you need one or more routers to route the packets between the two subnets. Cisco 200 Series Smart Switches...
Page 9
These ports are also commonly referred to as miniGigaBit Interface Converter (miniGBIC) ports. The term SFP will be used in this guide. • SFP ports are compatible with Cisco modules MGBT1, MGBSX1, MGBLH1, MGBLX1, MGBBX1, MFELX1, MFEFX1, and MFEBX1, as well as other brands of modules.
• To restore the smart switch configuration to the factory default settings: 1. Disconnect the smart switch from the network or disable all DHCP servers on your network. 2. With the power on, press and hold the Reset button for more than 10 seconds. Cisco 200 Series Smart Switches...
Cisco Firmware Downloads www.cisco.com/go/smallbizfirmware Cisco Open Source www.cisco.com/go/ Requests smallbiz_opensource_request Cisco Partner Central www.cisco.com/web/partners/sell/smb (Partner Login Required) Product Documentation Cisco 200 Series Smart www.cisco.com/go/200switches Switches Regulatory, Compliance, and www.cisco.com/en/US/docs/switches/ Safety Information lan/csb_switching_general/rcsi/ Switch_RCSI.pdf Warranty Information www.cisco.com/go/warranty Cisco 200 Series Smart Switches...
Page 12
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners.
Page 13
McGrp.Ru Сайт техники и электроники Наш сайт McGrp.Ru при этом не является просто хранилищем инструкций по эксплуатации, это живое сообщество людей. Они общаются на форуме, задают вопросы о способах и особенностях использования техники. На все вопросы очень быстро находятся ответы от таких же посетителей сайта, экспертов...