Changing The Intermittent Stroke - Brother BAS-326G Service Manual
Direct drive programmable electronuc pattern sewer
Hide thumbs
Also See for BAS-326G:
- Instruction manual (84 pages) ,
- Manual de instrucciones (84 pages) ,
- Parts manual (82 pages)
Table of Contents
Advertisement
7. ADJUSTMENT
7-13. Changing the intermittent stroke
The intermittent stroke can be adjusted to within 2 − 10 mm by adjusting the position of the stepping clamp connecting rod
and changing the installation position of stepping clamp link A.
<Changing the installation position of stepping clamp link A>
5010Q
1. Remove the face plate.
2. Remove the two screws (1) and the two shoulder screws (2), and then remove stepping clamp link A (3).
3. Change the installation position for stepping clamp link A (3) to either A, B or C above.
If the position of the stepping clamp connecting rod is adjusted as described in the following at any one of the installation
positions, the adjustment range for the intermittent stroke will as given in the following table.
Installation position
A
B
C
98
Intermittent stroke range
2 − 4.5mm
4.5 − 10mm
0 mm (Presser foot does not move up and down)
5012Q
BAS-311G, BAS-326G
5011Q
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
