Advertisement
Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. SafETy
ELEcTRIcaL SafETy
1.1.
WaRNING! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey dealer.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
Electrical safety information, it is important that the following information is read and understood.
1.1.1.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3.
Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
1.1.4.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2.
SafETy aND maINTENaNcE.
Keep the log splitter clean for best and safest performance.
9
Maintain the log splitter in good condition (use an authorised service agent).
9
Use a qualified person to lubricate and maintain the log splitter.
9
DO NOT use brake fluid to top up hydraulic unit.
8
DO NOT operate the log splitter if damaged.
8
Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
1.3.
WORKSHOP/ENVIRONmENTaL SafETy.
locate the log splitter on dry, level and solid ground in a suitable work area with adequate lighting.
9
Keep the area clean and tidy and free from unrelated materials. DO NOT leave tools, logs or other items lying around where they could
9
become a tripping hazard.
DO NOT operate the log splitter in wet or damp areas or expose it to rain.
8
DO NOT operate the log splitter in areas where fumes from paint, solvents, or flammable liquids pose a potential hazard.
8
1.4.
OPERaTOR SafETy.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery, and contain long hair.
9
Wear protective, electrically non conductive gloves .
9
Always wear safety goggles. everyday spectacles are not sufficient protection.
9
Maintain correct balance and footing, DO NOT over-reach. ensure the floor is not slippery and wear non-slip, protective footwear.
9
DO NOT allow untrained persons to operate the log splitter.
8
DO NOT operate the log splitter with the guards or guides removed.
8
DO NOT operate the log splitter when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT attempt to load a log until the log pusher has returned to the stop position.
8
Stay alert and always pay attention to the movement of the log pusher.
9
The log splitter must always be operated by one person only.
9
Keep hands away from the moving parts of the log splitter.
9
Keep hands away from splits and cracks which open in logs. They may close suddenly and crush or cut off parts of your hands.
9
© Jack Sealey limited
5.5 TON LOG SPLITTER 1050mm caPacITy
Model no:
Wear protective
Wear safety
gloves
footwear
Original Language Version
LS1050V
Warning
Warning
crushing of
hands
Recommended fuse rating
13 Amp
lS1050V Issue 3 (HF) 25/06/18
Advertisement
Table of Contents
Related Manuals for Sealey LS1050V
Summary of Contents for Sealey LS1050V
- Page 1 LS1050V Model no: Thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
-
Page 2: Specification
No: ........ -
Page 3: Set Up And Preparation
54cm, 79cm and 105cm. Decide which table capacity is most appropriate (see fig.6) and cut fig.6 the wood slightly shorter than the stated length. Insert the table into the Original Language Version lS1050V Issue 3 (HF) 25/06/18 © Jack Sealey limited... - Page 4 6.4.10. Stack as you work to keep the work area hazard free. Clean up accumulated wood chips and other debris to keep the work area safe. Original Language Version lS1050V Issue 3 (HF) 25/06/18 © Jack Sealey limited...
-
Page 5: Maintenance
7. maINTENaNcE 7.1. checking the oil. Check the oil level regularly as low oil levels can damage the pump. Sealey hydraulic oil is available in 500ml containers (Part no: HJO500mLS) or 5ltr containers (Part no: HJO5LS). 7.1.1.