free stats
NEC Versa LX Manual

NEC Versa LX Manual

Hard disk drive upgrade kit
Hide thumbs Also See for Versa LX:

Advertisement

®
NEC Versa
LX and LXi
Hard Disk Drive Upgrade Kit
original hard disk drive is installed in the internal bay because it will permanently destroy the
data on the original hard disk drive. ONLY boot the system with the CD when the new hard
disk drive is installed in the internal bay.
Congratulations on purchasing the NEC Versa Hard Disk Drive Upgrade Kit. The upgrade kit is
designed to support the NEC Versa LX and LXi systems with user-removable hard disk drives.
Note
(NEC Versa LX systems only.) For hard disks, 12-GB or larger, the restore process
creates two partitions, not a single partition as shipped from the factory. If you want to create a
single partition for your hard disk drive, you should run the Partition Magic software (version 4.1
or higher) after the restore process completes. Partition Magic can either be downloaded from a
URL address provided by NECC Customer Support, or installed from the Application and Driver
CD that ships with your system (not available on all CDs). See the document, Restoring a 12-GB
or Larger Hard Disk Drive, which shipped with your hard disk, for detailed instructions on using
the Product Recovery CD and/or creating a single partition with Partition Magic.
In addition to introducing the hard disk drive upgrade kit contents, this sheet describes the
following.
T
Instructions for identifying your system's user-replaceable hard disk drive (for NEC Versa
LX only).
T
Instructions on removing the internal hard disk drive.
T
Instructions on removing the hard disk drive from the cradle pack.
T
Instructions on installing the new drive in the drive bay.
T
Instructions on installing the system's original drive into the cradle pack.
T
Instructions for copying the contents of your original hard disk drive to your new hard disk
drive.
T
Instructions for verifying the data transfer.
To be sure that you own a unit with a user-replaceable hard disk drive (for NEC Versa LX only),
check the following.
T
Turn your system over. Note the label on the back of the unit, which contains the Doc ID
(model name), Model Number, and NEC Serial Number for the unit.
T
Look at the 14-alphanumeric characters in the model number. A unit with a user-replaceable
hard disk drive has the letter "A" in the next to last position of the model number. An
example of a model number for a unit with a user-replaceable hard disk drive is VL210010-
0000A0.
NEVER boot the system with the CD (supplied with this kit) when the
NEC Versa LX and LXi Hard Disk Drive Upgrade Kit 1

Advertisement

Table of Contents
loading

Summary of Contents for NEC Versa LX

  • Page 1 Instructions for verifying the data transfer. To be sure that you own a unit with a user-replaceable hard disk drive (for NEC Versa LX only), check the following. Turn your system over. Note the label on the back of the unit, which contains the Doc ID (model name), Model Number, and NEC Serial Number for the unit.
  • Page 2: Removing The Internal Hard Disk Drive

    Removing the Internal Hard Disk Drive The hard disk drive is located under the battery bay in your NEC Versa notebook computer. You must remove the system’s main battery before removing the hard disk drive. Remove the hard disk drive as follows.
  • Page 3: Removing The Battery

    Slide the battery release latch toward the back of the system and hold firmly. Locating the latch A — Battery Release Latch Continue to hold the battery release latch as you slide the battery out of the system. Removing the battery NEC Versa LX and LXi Hard Disk Drive Upgrade Kit 3...
  • Page 4: Disconnecting The Drive

    Disconnecting the drive Once the drive is disconnected, use the lever to lift the drive out of the system. Once removed, only handle the drive by its sides. 4 NEC Versa LX and LXi Hard Disk Drive Upgrade Kit...
  • Page 5 With the lever raised, place your fingers on the inside edge of the lever and on each side of the center notch. Pull the drive away from the drive connector. Lift the drive out of the cradle. NEC Versa LX and LXi Hard Disk Drive Upgrade Kit 5...
  • Page 6: Connecting The Drive

    Do not apply pressure to the drive surface as you push. Connecting the drive A – Drive Connectors Press down on both sides of the drive lever to lock it into place. 6 NEC Versa LX and LXi Hard Disk Drive Upgrade Kit...
  • Page 7 Align the drive connector with the cradle pack connector. Lowering the drive into the cradle A – Hard Disk Drive Lever B – Cradle Pack Connector NEC Versa LX and LXi Hard Disk Drive Upgrade Kit 7...
  • Page 8 Launching the Copy Utility Make sure that the CD-ROM drive and the new hard disk drive are installed in your NEC Versa notebook. Insert the NEC Hard Drive Upgrade Setup CD into the drive and power on the system. Use the following steps to run the Copy utility.
  • Page 9 Your original disk drive can be used as a second drive in the VersaBay III. Note (NEC Versa LX systems only.) For hard disks, 12-GB or larger, the restore process creates two partitions, not a single partition as shipped from the factory. If you want to create a single partition for your hard disk drive, you should run the Partition Magic software (version 4.1...
  • Page 10 819-200649-001 10/2000 '%&(#!&(' 10 NEC Versa LX and LXi Hard Disk Drive Upgrade Kit...

This manual is also suitable for:

Versa lxi

Table of Contents