UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
Page 2
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS REMANUFACTURING THE DELL 5100CN TONER CARTRIDGE By Javier Gonzalez and the Technical Staff at UniNet DELL 5100CN TONER CARTRIDGE 1. Remove the gearless end cap (shown) to access the toner fill cap. Using a small flat head screwdriver, carefully pry out one side of the end cap to unlock it from the first set of tabs.
Page 3
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 4. Carefully slide out the gearless end cap. 5. Carefully insert a small flat head screwdriver between the base of the toner fill plug and its housing as shown. Note the original positioning for reassembly.
Page 4
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 8. Locate and grab hold of the gear side end cap (circled). 9. Cartridge separated. Remove the outer tube by sliding it out as shown. Note the original positioning of the outer tube. Clean thoroughly using compressed air.
Page 5
NOTE: Optional UniNet Clearseal ™ universal adhesive for use in Dell 5100cn OEM C/M/Y/K toner cartridges (part #10353). 14. Gently wrap the seal flap around the toner fill opening as 15. Slide the cartridge into the tube until it is completely shown before inserting the cartridge.
Page 6
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 16. Final result. 17. Place the cartridge in a vertical position and refill with the appropriate amount of toner for use in Dell 5100cn. Install the You are now ready to fill the cartridge. fill plug.
Page 7
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 19. Place the gearless end cap, in its original positioning, over 20. Push the end cap inward until it is properly secured by all the seal and toner fill plug as shown. Make sure that the four locking tabs.
Page 8
DELL 5100CN TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS 23. Be sure to wear latex gloves when handing chips. 24. Unlock the actual chip from its housing by pressing on the small tabs shown using an angled hook tool. 25. Carefully pry the chip from its housing.