Advertisement
Quick Links
thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear eye
instructions
protection
1. Safety
1.1.
electrical Safety
warNiNG! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
electrical safety information, it is important that the following information is read and understood.
1.1.1.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
1.1.3.
important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO NOt pull or carry the appliance by the power cable.
8
DO NOt pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a firm grip on the plug.
8
DO NOt use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or replaced immediately by a
8
qualified electrician.
1.1.4.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
Class II products are wired with live (brown) and neutral (blue) only are marked with the
Class II symbol;
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
C) After wiring, check that there are no bare wires and ensure that all wires have been correctly
connected.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
DO NOt connect either wire to the earth terminal.
8
It is recommended that repairs are carried out by a qualified electrician.
1.2.
GeNeral Safety
disconnect the mixer from the mains power before changing accessories, servicing or performing any maintenance.
9
maintain mixer in good condition. Check moving parts and alignment of mixing paddle. If necessary use an authorised service
9
agent.
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Wear approved safety eye protection and a dust mask if mixing generates dust. Rubber gloves are recommended.
9
Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain long hair.
9
Use mixer in an adequate working area for its function, keep area clean, tidy and free from unrelated materials and ensure adequate
9
lighting.
DO NOt over-reach and ensure the floor is not slippery and wear non slip shoes. maintain correct balance and footing.
8
Always use both handle grips during use.
9
Keep children and unauthorised persons away from the working area.
9
Avoid unintentional starting of the mixer.
9
DO NOt use the mixer for a task which it was not designed to perform.
8
DO NOt operate mixer where there are flammable liquids or gasses.
8
DO NOt get the mixer wet or use in damp or wet locations.
8
DO NOt operate the mixer if any parts are missing or the mixer is damaged as this may cause failure and/or possible injury.
8
DO NOt operate the mixer when you are tired, under the influence of alcohol, drugs or intoxicating medication.
8
DO NOt carry the mixer with your finger on the power switch, or carry by the power cord, or leave the mixer running whilst
8
unattended.
When not in use switch mixer off, remove plug from power supply, clean the mixer and store in safe, dry, child proof area.
9
© Jack Sealey limited
electric mixer 80ltr 1220w/230v &120ltr
1400w/230v
model no:
Wear protective
Wear safety
footwear
gloves
Original Language Version
Pm80l, Pm120l
Wear ear
protection
Recommended fuse rating
13 Amp
PM80L, PM120L Issue:2(SP) - 31/07/18
Advertisement
Related Manuals for Sealey PM80L
Summary of Contents for Sealey PM80L
- Page 1 Pm80l, Pm120l model no: thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson way, Suffolk Business Park, Bury St edmunds, Suffolk. iP32 7ar 01284 757500 01284 703534 sales@sealey.co.uk...