Table of Contents
Advertisement
Figure 35. Installing the 2.5-inch drive cage cover
Next steps
1.
Install the drive cage into the PSU 2
2. Follow the procedure listed in
Removing 2.5-inch cabled drives from the drive cage
Prerequisites
NOTE:
To identify the drive, see the label on the drive cable. For more information, see Drive Specifications in the
PowerEdge C4140 Technical Specs at .www.dell.com/poweredgemanuals.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Keep the Phillips #2 screwdriver ready.
4.
Remove the 2.5-inch drive
5.
Remove the 2.5-inch drive cage
Steps
1. Remove the screws securing the drive to the drive cage.
NOTE:
If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the screws securing the drive to the
drive cage.
2. Remove drives 0 and 1 by performing the following steps:
a. Disconnect the signal and power cable from the drives.
b. Lift drive 0 out of the drive cage.
c. Slide drive 1 out of the drive cage.
bay.
After working inside your
Safety instructions
Before working inside your
cage.
cover.
PowerEdge C4140 installing and removing system components
system.
section.
system.
37
Advertisement
Table of Contents
