Table of Contents
Advertisement
The table below describes the media library parameters that must be enabled by a
service technician when the Canon Controller and UI are attached.
Characteristics
Adj. Ppr Separation Fan Level
Adjust Paper Curve
Adj. Paper Realignment Speed
Correct Image for Scratching
Adjust Lead/Tail Margins
Toner Amount Reduct. Mode
Adj. Secondary Transfer Volt.
Adjust Antistatic Bias
Adjust ITB Image Clearing
Adjust Gloss/Fine Black
Change Fold/Stitch Position
Adj. Saddle Stitch Fold Pos.
Adjust Saddle Fold Position
Adjust Hole Punch Position
Corr. Tail End Toner Applic.
Adjust Fixing Speed
Adjust Fixing Pressure
Auto Adj. L/R Edge Alignment
Adj. Primary Transfer Voltage
109 It is recommended to adjust the values in small increments, as increasing the value too much may
cause paper jams.
110 If the Correct Image for Scratching mode is set to 'On', it may affect the print speed of the machine.
111 Adjusting the Secondary Transfer Voltage setting may affect the 'Adjust ITB Image Clearing' and 'Corr. Tail End
Toner Applic' settings. Readjust these settings, if necessary.
Version 5
imagePRESS C910/C810/C710 Customer Expectations Document
Specify how to adjust the paper separation fan output from optional
POD Deck Lite-C1 and Multi-Drawer Paper Deck-C1.
Adjust the paper curve setting when the printed image looks like a
trapezoid. Increase the paper curve value to correct a distorted
image. Decrease the setting value to correct the paper from
creasing, curving marks, or curled edges.
Adjust the speed for adjusting the image position.
Select 'On
which has been stored in a low-temperature environment, is being
used.
Adjust the lead and tail end margins if the output paper is folded or
bent at the corner, or if paper jams occur.
Adjust the total amount of toner used for each paper type. Select
'On' for this setting to reduce the total amount of toner used, while
retaining the CMYK values specified in the Color Balance mode.
Adjust this setting to correct blurred images.
Adjust this setting if the image is blurred or a paper jam occurs in
the transfer unit. Decrease the antistatic bias value to remove static
electricity from the ITB (Intermediate Transfer Belt).
Specify how to adjust the toner residue on the ITB that may transfer
to the paper.
Specify how to adjust the glossiness and fine black print on a
109
custom paper type.
Adjust the saddle fold/stitch position if the folds of the paper are not
exactly in the middle of the booklet.
Adjust the position of the folds in a booklet, if the stitches appear in
the center of a booklet, but the folds do not appear in the center.
Adjust the position of the saddle folds in the center of the paper.
Depending on the paper type, adjust the position of the punch
holes.
Adjust the amount of toner applied to the tail-end of the paper.
Adjust the fixing speed if long originals, envelopes, thin paper, or
paper that has absorbed moisture is being used to improve paper
curl and creasing.
Adjust the fixing pressure if adjusting the fixing speed did not work.
Adjust to prevent the printed image from being misaligned vertically,
as seen from the paper feeding direction.
Adjust to prevent blurred images that may occur if paper with a
longer width is used after copying/printing a large amount of paper
with a shorter width. For example, using 11" x 17" paper after LTRR
paper.
imagePRESS C910/C810/C710 Customer Expectations Document
Parameters
110
' for this setting to improve image quality if paper,
111
Page 121
Advertisement
Table of Contents
