Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear protective
instruction
gloves
manual
1. SAFETY
NOTE: This is a temporary structure and is not recommended as a permanent structure.
Choose your shelter's location carefully. Check for overhead utility lines, branches, etc. DO NOT install near roofs or other structures that
9
may shed snow, ice or excessive run-off onto your shelter. Keep away from electrical wires!
Have an overview of all parts before attempting installation. Make sure all components are available.
9
DO NOT use this product in environments for which it is not intended (i.e. extreme cold, high winds, extreme heat, heavy rainfall, etc).
8
Always wear safety glasses when assembling this product. Wear gloves when working with tubing to prevent cuts or abrasions.
9
WARNING! Anchors must be used with alI shelters. Covers should NOT be installed untiI it has been properly anchored to the ground.
‰
NOTE: Proper anchoring and keeping cover tight and free of snow and debris, is the responsibility of the consumer. Damages caused
by improper anchoring are not covered under warranty.
WARNING! Keep all flame and heat sources away from the shelter fabric. The fabric will burn if left in continuous contact with a flame
‰
source.
DO NOT use open flames or cooking or heating devices inside or in close proximity to the product, including all types of stoves, gas
8
heaters, gas lanterns, citronella torches, mosquito coils, etc.
WARNING! In order to reduce risk of burning and avoid damage, DO NOT:
‰
- cook, smoke, refuel or use any open flame devices in or around the shelter.
- store flammable liquids (gasoline, kerosene, propane, etc.) in the shelter.
- operate gas powered equipment in or around the shelter.
WARNING! Keep open flames a safe distance away from the shelter.
‰
DO NOT use hard-edged tools or instruments, such as rakes or shovels, to remove snow. These can cause punctures to the cover.
8
▲
NEVER start the engine of any vehicle or machine inside a closed shelter. Ensure that there is adequate ventilation for starting
engines and for any work with paints, cleaners, etc.
DO NOT use bleach, alkaline or harsh detergents for cleaning. Doing so will damage the polycarbonate material. Soap and warm
8
water are recommended.
This temporary shelter is intended to offer protection from damages caused by the sun, light rain, light snow, tree sap, bird and animal
9
excrements. DO NOT use it to shield goods from high winds, heavy snow or ice storms. Only use it for its intended purpose.
2.
INTRODUCTION
i
Made from durable anti-scratch material to protect vehicle's paintwork. Rigid tubular frame with hinged opening for easy access.
Hook and loop vents allow increased ventilation while still keeping vehicle protected from elements. Includes anchor points for fixing
shelter to driveway/ground (fixings not included). Padlock hasp and additional ground anchor point for increased security when canopy is
closed.
3.
SPECIFICATION
i
Model No: ...................................................................CCS01
Dimensions (W x D x H) ..............................2.7 x 5.5 x 2 mtrs
4. ASSEMBLY
4.1.
ASSEMBLY PREPARATION
4.1.1.
Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you.
4.1.2.
Remove all packaging materials and place them back in the box. DO NOT dispose of the packaging materials until assembly is
complete.
4.1.3.
Check for completeness of components and transport damages.
WARNING! DO NOT place the product under trees from which hard fruit such as apples, walnuts or heavy pine cones, etc., may fall.
‰
4.1.4.
Keep children away during assembly. This product contains small parts which can be swallowed by children.
DO NOT attempt to assemble the product if any parts are missing.
8
4.1.5.
At least 2 people are needed to complete the assembly as some of the steps require awkward lifting and fitting.
WARNING! DO NOT leave the shelter unattended during assembly. Otherwise, personal injury or damage to the shelter may occur.
‰
© Jack Sealey Limited
INSTRUCTIONS FOR
VEHICLE STORAGE SHELTER (2.7 X 5.5 X 2MTRS)
CCS01
MODEL NO:
Wear eye
protection
Original Language Version
CCS01 Issue 1 13/04/18
Advertisement
Related Manuals for Sealey CCS01
Summary of Contents for Sealey CCS01
- Page 1 CCS01 MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 D except they are slightly longer. Take care to select the correct items C at this stage. fig.1 fig.2 4.2.2. Securely assemble centre spar using items M (M6 x 60 bolt arrangement) (fig.3) fig.3 CCS01 Issue 1 13/04/18 Original Language Version © Jack Sealey Limited...
- Page 3 The shelter is provided with four anchor point plates (ground fixings not supplied). These are fitted to the main frame bases (items A) as shown in fig.7 and fig.8. Ground fixings NOT supplied supplied fig.7 fig.8 CCS01 Issue 1 13/04/18 Original Language Version © Jack Sealey Limited...
- Page 4 Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk...