Table of Contents
Advertisement
Attaching Front-Mount Brackets to the Chassis
Figure 1: Positioning an Expanding Bottom-Support Rail Set
1
2
Step 5
Repeat Steps 2 and 3 to attach the other expanding bottom-support rails to the other side of the rack.
Check the two installed bottom support rails to be sure that both have their chassis stops by the same aisle
Note
(either both by the hot aisle or both by the cold aisle) and that both rails are level and level with each other. If
they are not level, adjust the higher rail down to the level of the lower rail.
What to do next
You are ready to install two front-mount brackets on the chassis.
Attaching Front-Mount Brackets to the Chassis
You need to attach a right-angled bracket to each side of the chassis. This bracket holds the chassis in place
on a four-post rack.
Cisco Nexus 9336PQ ACI-Mode Switch Hardware Installation Guide
18
2 screws holding one end of
the bottom-support bracket
to the rear of the rack
Chassis stop on the
expanding bottom-support
bracket
3
Installing the Chassis
2 screws holding the front
end of the bottom-support
bracket to the front side of
the rack
Advertisement
Table of Contents
